Publish Time: 2022-02-27 Origin: Site
The magnetic door stop is a kind of door top used to support the door. It includes a bottom plate with an L-shaped cross section and a slot plate with slots and installed on the outer side of the long arm of the bottom plate. The lower end of the slot plate is fixedly connected with a ball device. It is provided with a screw and a nut for installing the groove plate. When installed at the bottom of the door, it can effectively prevent the door from deflection and deformation.
The door slam stopper may have aging problems after being used for a long time. The performance of a broken door is that there is no suction, and it can't hold the door. If the metal door stopper is not replaced in time, the door and wall may be damaged. How should we adjust and replace the door stop when it is broken?
1. Remove the loose door draft stopper, install the door stopper on the wall (or the ground), and insert an appropriate small wooden block.
2. Re-fix the fixing bolt of the door stopper at the installation position. The fixing method of the sliding door draft stopper is to tighten it clockwise. If it is still not tightened, it means that the expansion screw connecting the spring loaded door stop is loose. You need to find something to fix it before you can tighten the door stop bumper.
3. Suppose you use a hammer and nail to drive the stop back to its original position. Then nail the nail every 12 inches or as needed. Finally, the damaged wall is decorated with paint or varnish, and the work of adjusting the stainless steel door stop is completed.
1. Use the ball lock accessory with an iron piece specially designed to remove the grip and insert it into the small hole under the grip.
2. Follow the previous step to easily unscrew the grip.
3. Use a flat-head screwdriver to pry up the gasket behind the handle.
4. Use a Phillips screwdriver or an electric screwdriver to loosen the fixing screws in the ball lock.
5. Take out the old ball lock from the other side of the ball lock.
6. Use an electric screwdriver or a cross screwdriver to remove the lock bolt.
We are a manufacturer specialized in producing all kinds of door knob bumpers and brass cabinet hardwares in China, with a history of more than 10 years. Our products are exported to more than 50 countries and received unanimous praise. If you are interested in these products, welcome to send us your inquiry.